There are eight designs in this set.  The designs may be stitched with either a single needle (redwork style) or a twin needle (twin needle shadow work style). Included with your embroidery files will be a PDF (eleven pages) with notes on setting up your machine.

I recommend a size 1.6 or 2.0 twin needle for all these designs.  PLEASE consult your machine manual for information on threading for twin needles.  Note that some machines offset the needle bar when in embroidery mode.  They will require a needle specifically for that machine and in size 1.6.  

Suggested supplies for twin needle designs:

  • Two spools of selected thread; fine embroidery cotton is preferred.
  • Extra bobbin case, for adjustments OR adjustment to the case itself (such as a Bernina 830)
  • Twin needle, size 1.6 or 2.0.
  • 7mm  or 9mm needle plate
  • Machine embroidery foot with wide opening, large enough to accommodate the twin needle you choose.
  • Optional:  crystals and/or an assortment of beads and charms to decorate the trees.  

Shown above are several designs and the blocks on a table runner/wall hanging.  The entire piece can be seen below.  I used batiste for the white blocks and quilting cottons to complete the top and back. I chose Warm and White batting and free-hand stippled the runner.

Formats available: ART, DST, EXP, HUS, JEF, PES, VIP, VP3, and XXX. ​Some designs may be rotated to fit hoops in other formats than ART. The larger design may not fit all hoops. ​Files will be sent within 24 hours of purchase.  If you do not find your files, please first check your spam box, then contact


Christmas Trees